 Hydrogen Gas
Saver -
How
To Make
A HHO Gas Saver
Even though Stanley Meyer first discovered the principle it in the
late 90's, hydrogen gas savers have been very popular for the last two
years.
These devices are basically a recipient, like a jar, filled with water
and with wire and hose connectors on the lid. But once properly
installed on a car, they have a uniquely amazing power! They are
producing a gas that will improve your fuel efficiency.
The average fuel economies are between 30% and 50%, but it's not rare
to see people saving 60% and sometimes even more.
There are books that will give you easy to follow step-by-step
instructions. They
are conscious that not only "mechanics peoples" would like to save some
money on fuel.. So they managed to make the information easy to
understand
for the big majority of people out there.
If you
follow everything that is suggested, it should be easy to
assemble.
Of course, it does
require a few hours of work to read the book,
assemble the hydrogen gas saver
and to install the generator on the car.
 But you can always ask a mechanic you know
to install it for you.
They are most of the
time extremely interested into anything related to
car improvement. And especially when they can learn how to
build
systems to save 30% to 50% on gas..
believe me !
Here is a
very condensed
resume of
the installation process
A Few
Holes :
You will have to pierce three little holes in the lid of the
recipient.
Two holes will be used to install two connectors. You will have to fix
wires from the hydrogen gas saver to the battery posts.
2
Wires :
One will go from your battery to a fuse, then to the ignition switch,
and finally to the battery. The
second wire will go from the device straight to the other
battery post. And
the third hole will serve to transfer that hydrogen gas from the device
to
your engine.
Few Hose
Cables + T's :
You
will have to split the exit of the third hole.. and connect two hose
cables there.
One will be connected to the air intake manifold of the car.
The
second hose will go through the engine.
 Reading
& Testing Material:
Of course you will
have to first read
the
book, and it is essential to read everything. And once the assembling
and installation of the hydrogen gas saver are completed, it is
suggested
to go
throught a little testing routine to make sure it works fine.
But
don't
worry, everything is explained in the
books.. And there is also a
technical support offered in case you're having
difficulties.
Can
This Damage Your Car Or Warranty ?
Absolutely not. In fact the
modification can be removed very quickly.
It is an experimental
add-on
that can be removed in less than 60 seconds.
How
Do You Save Money ?
When
you will turn the ignition switch on, this will activate the hydrogen
gas saver and activate the electrolizing process. After a few seconds,
the
water will produce a grey-brown gas that will fill the device.
This is the HHO gas. And this HHO gas, also know as brown's gas, is
the special ingredient that will dramatically improves the fuel
efficiency
of your car.
|
